Filter
Top Products
H7678 18 Gauge Deep Stapler Kit
-8-
OPERATIONS
Loading
When replacing staples in your Model
H7678, follow these guidelines:
Gauge: 18
Length:
3
⁄8
"
–1
1
⁄2"
Capacity: 100
Crown:
1
⁄4
"
To load your stapler:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
2. Grip the stapler firmly, unlock the catch
lever (Figure 3) and pull the magazine
pusher back.
Figure 4. Loading staples into magazine.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate
the stapler.
Before you operate your stapler, place two
to three drops of the included pneumatic
tool oil into the quick connect fitting where
the stapler connects to the air supply.
To operate your stapler:
1. Connect the air supply to the quick
connect fitting.
2. To test for proper staple penetration,
hold the stapler perpendicular to the
surface of a piece of clean scrap wood
that is thick enough for the length of
staples you have loaded.
4. Slide the staples all the way down to
the nose of the stapler.
5. Slide the magazine pusher toward the
nose of the stapler until the catch lever
locks.
Figure 3. Unlocking catch lever.
Catch Lever
Magazine
Pusher
Pusher
3. Point the stapler up and insert a stick
of staples, pointed-end up, into the
bottom of the magazine, as shown in
Figure 4. Make sure that the pointed
ends of the staples point in the same
direction as the stapler nose piece.