Filter
Top Products
H7678 18 Gauge Deep Stapler Kit
-7-
Safety Yoke
A safety yoke mechanism on the nose of
the stapler acts as a safety device. When
the trigger is pressed, the stapler will not
fire until the safety yoke mechanism is
depressed.
Before you use your stapler for the first
time, check the safety yoke mechanism to
ensure proper function. To do this:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
2. Make sure the magazine is empty and
contains no staples.
3. Make sure the trigger and the safety
yoke mechanism move up and down
without sticking.
4. Connect the stapler to the air supply.
5. Without pressing the trigger, depress
the safety yoke mechanism against a
scrap piece of wood that is clean and
free of any knots, nails, or other foreign
objects.
— If the stapler does not fire, then the
safety yoke mechanism is working
correctly.
— If the stapler does fire when you
do this, immediately disconnect the
stapler from the air supply and call
Grizzly Technical Support at (570)
546-9663 for help.
— If the stapler fires when the trig-
ger is pulled, without the safety
yoke mechanism being depressed,
disconnect the stapler from the air
supply and call Grizzly Technical
Support at (570) 546-9663 for help.
— If the stapler is not working properly,
check the lubrication of the sliding
mechanisms of the safety yoke.
The safety yoke is a mechanical
device that can fail. Never rely on the
safety yoke mechanism as an excuse
to point the stapler at yourself or any
bystanders. Serious injury may occur.