Grizzly H7678 Staple Gun User Manual


 
H7678 18 Gauge Deep Stapler Kit
-2-
1. HAND INJURIES. Do not place your
hands near the staple point of entry.
A staple can deflect and tear through
the surface of the workpiece, punc
-
turing your hand or fingers.
2. COMBUSTIBLE GASES. Never
connect the stapler to pressurized
oxygen or other combustible gases
as a power source
. Only use fil-
tered, lubricated, and regulated
compressed air.
3. SAFE HANDLING. Never point the
stapler at others! Do not keep the
trigger pulled when loading fasten-
ers, carrying, or holding tool. Carry
the stapler only by the handle, never
by any other part. Do not carry the
stapler by the air hose. Disconnect
the stapler from the air hose when
going up and down ladders.
4. CLEANING. Never use gasoline or
other flammable liquids to clean the
stapler; vapors in the stapler will
ignite by a spark and cause it to
explode.
Additional Safety Instructions for Staplers
5. HOSE USAGE. Make sure your
air hose is designed for the tool
in use, is in good condition, and
is long enough to reach your work
without stretching. However, an
overly long air hose in the work
area may be a tripping hazard.
6. OPERATING QUESTIONS. If you
are not sure about the intended
operation, stop using the stapler.
Seek formal training or research
books or magazines that special-
ize in pneumatic tools.
7. MAINTENANCE. Always discon-
nect air from the stapler when ser-
vicing or installing staples. During
maintenance, a stapler connected
to air may fire accidentally, caus-
ing serious personal injury.
8. COMPRESSED AIR RATING. Do
not connect the stapler to com-
pressed air that exceeds 120 PSI.
9. CHECK VALVE. Do not use a
check valve or any other fitting that
allows air to remain in the tool.