Filter
Top Products
H7678 18 Gauge Deep Stapler Kit
-12-
CLEANING & LUBRICATION
Cleaning
Disconnect the stapler from the air supply
before cleaning. Use a good solvent to
clean the nose assembly of the stapler.
Always be sure that the stapler is dry
before using it again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
stapler; this may result in leaks and dam-
age to the stapler and the air couplings.
Lubricating
Pneumatic tool oil has been included with
your new Grizzly stapler to help maintain
its useful life. Place two to three drops
of oil in the stapler air inlet (as shown in
Figure 7) before every use, or after 2
hours of continuous use.
Wipe off any excess oil near the stapler
exhaust to avoid dust build-up. When
the oil that was included with the stapler
has been completely used, replace with
Grizzly Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compres-
sor line. If your air compressor line already
has a lubricator, then regular lubrication
of your stapler will not be necessary.
Just make sure there is always oil in the
lubricator.
Figure 7. Lubricating stapler via air inlet.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!