Filter
Top Products
Model H8125 9.6V Mini Grinder Kit-10-
DO NOT use bits or cutters with
a cutting surface larger than 1".
The bit could break apart under the
stresses of high speed use causing
serious personal injury.
4. Use the small switch on the underside
of the light attachment to switch the
LED's ON and OFF.
Installing Bits
The Model H8125 uses bits and cutters
with a
1
⁄8" or a
1
⁄4" diameter shaft. See the
Grizzly catalog or www.grizzly.com for
a complete listing of available bits and
accessories.
To install a bit:
1. REMOVE THE BATTERY FROM THE
GRINDER!
2. Depress the collet lock (see Figure 3)
and loosen the collet nut with the collet
wrench. The collet lock will engage as
the collet rotates.
Note: It is not necessary to com-
pletely remove the collet nut from the
shaft unless you are also changing the
collet.
Using the LED Light Attachment
The LED light attachment illuminates low
light operations and is easily mounted on
the grinder.
To install and use the LED Light
Attachment:
1. REMOVE THE BATTERY FROM THE
GRINDER!
2. Unscrew and remove the collet shield
from the nose of the grinder.
3. Thread and hand-tighten the light
attachment onto the grinder (see
Figure 2).
to install a bit
LED
Switch
Collet Lock
Collet Nut
Figure 2. LED light attachment installed.
Figure 3. Collet lock.