Filter
Top Products
SKU 44506 For technical questions, please call 1-800-444-3353. Page 5
9. Do not mount (or adjust) the workpiece on the Drill Press Table while the motor is
running.
10. When drilling or cutting large holes, use the slower speeds and securely fasten the
workpiece to the table using a mounted vise.
11. Do not use drill bits that extend more than six inches from the Chuck.
12. Do not use circle cutters, rotary planers, wire wheels, router bits, or shaper cutters on
this Drill Press.
Unpacking
When unpacking, check to make sure the following parts are included. Refer to the Parts
Lists and Assembly Drawings located at the end of this manual.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
Assembly
Assembly hardware is located in one box and one bag. Each contains the necessary parts
for each assembly step. Remove all packing and protective material from the Drill Press
components.
1. Position the Base (C4) on a level and sturdy table for mounting.
It is recommended to bolt the Base to the table using appropriate hardware (not
supplied).
2. Place the Support Tube (C3) on the Base, aligning the mounting holes.
3. Insert three large Hex Screws (C5) into the mounting holes and tighten with a wrench.
Head (1) Assembly
Motor (7)
Table (C7)
Support Tube (C3)
Base (C4)
Table Support (C1)
Locking Switch (21)
Bag of Loose Parts
Box of Loose Parts