Filter
Top Products
SKU 44506 For technical questions, please call 1-800-444-3353. Page 10
8. Pull the Feed Knob and check the spring tension, making sure the up movement is
smooth and complete.
From one inch down, the Chuck should return to its uppermost position. If more
tension is required, repeat steps.
9. Replace the (outer) Hex Nut and tighten on top of the (inner) Hex Nut. Do not
overtighten.
10. If the (up/down) movement is restricted, slightly loosen the (inner) Hex Nut, and
retighten the (outer) Hex Nut.
General Maintenance
1. Using compressed air, blow clean the Table, Base, and Motor cooling vents of dirt and
materials.
2. Apply paste wax to the Table and Column to enable movement and to help keep
surfaces clean.
3. All bearings are factory lubricated and need no further attention.
4. Periodically, lubricate the Tube Column, Table, and Spindle upper teeth.
5. Monthly, check the tightness of all mounting screws and bolts in the Base, Column,
and Head assemblies.
6. Check belt for wear and replace if frayed or damaged in any way.
7. Lubricate Spindle assembly with a light oil, weekly.
8. Store in a clean and dry location.