Filter
Top Products
SKU 45378 Page 5 REV 05/03
Step 3) Attach the second Collector Support (#14) through the inside holes near
where the Motor Base (#5) will be mounted-see Figure 2. Insert Hex Screw (#6)
down through Washer (#4) and Base Plate (#3) and secure in place with Nut (#2)-
see Figure 2.
Step 4) The Fan Housing (#38) is attached to the Motor (#8) and Motor Base (#5)
as a single unit. Secure the Motor Base (#5) to the Base Plate (#3) using six (6)
Hex Screws (#6), six (6) Washers (#4) and six Nuts (#2)-see Figure 2 and 3.
Step 5) Set the Packing (#29) on top of the rectangular opening on the Fan Hous-
ing (#38) (see Step 4). Set the Outlet (#30) on top of the Fan Housing (#38) and
Packing (#29)-see Figure 4. Slide Washer (#16) onto Hex Screws (#15) and thread
into the six (6) holes in the lip of Outlet (#30), Fan Housing (#38) and Packing (#29).
Secure in place with Nuts (#2)-see Figure 4.
Collector
Support (#14)
Base Plate
(#3)
Hex Screw
(#6)
Figure 1
Collector Support (#14)
Hex Screw (#6)
Figure 2
Motor
(#8)
Motor Base
(#5)
Fan Housing (#38)
Motor (#8)
Motor Base (#5)
Figure 3
Base Plate (#3)
Hex Screw (#6)