Filter
Top Products
SKU 45378 Page 6 REV 05/03
Packing (#29)
Fan Housing (#38)
Outlet (#30)
Hex Screws (#15)
with Washer (#16).
Secure with Nuts (#2)
Figure 4
Hose Clamp (#31)
Hose (#32)
Step 6) Connect the Upper Bag Support (#13) to the Collector Support (#14) and
Collector (#33). Thread in both Hex Screws (#6) through the Collector Support
(#14) and through the Upper Bag Support (#13) and into the Collector (#33)-see
Figure 5.
Step 7) Slide the Hose Clamp (#31) onto the Hose (#32). Slide Hose (#32) with
Hose Clamp (#31) onto the Outlet (#30). Once the Hose (#32) is in place, tighten
the screw on the Hose Clamp (#31) until the Hose (#32) is securely fastened to the
Outlet (#30)-see Figure 4.
Step 8) Slide the Hose Clamp (#31) onto the other end of the Hose (#32). Slide
the top opening of the Hose (#32) over the duct in the Collector (#33). Tighten the
screw on the Hose Clamp (#31) until the Hose (#32) is securely fastened.
Step 9) Place the Filter Bag (#35) on top of the Collector (#33). Once the Filter
Bag is in place, adjust the clamp so that the clip rests between the teeth. Press
the clamp down to lock in place. Extend the bag so that the loop on the top hangs
on the Upper Bag Support (#13).
Upper Bag Support
(#13)
Collector Support (#14)
Collector (#33)
Hex Screws (#6)
Figure 5