Filter
Top Products
SKU 45378 Page 7
REV 05/03
Operation
This unit is designed for use with an existing dust system, or you can construct a
new system.
1. If constructing a new system, connect 4” vent pipe (not included) to the
4” Inlet (#24) Determine the size of the dust ports on your tools and run vacuum
hoses (not included) from each tool to an appropriate sized adapter (not included),
and into the 4” vent pipe (not included).
Warning! Do not tamper with or remove the grounding pole on the plug. You
must use this unit with a 3 pole receptacle. If you use an extension cord, it must
meet amperage specified (16 AWG), and the cord must be 3 pronged.
2. Make sure the Collection Bag (#36) is on tight and not leaking. Switch on the
unit using the toggle Switch (#9).
3. During operation, periodically check how full the Collection Bag (#36) is. Do
not let it fill more than 3/4 full. A completely full bag puts a lot of stress on the bag
and the belt.
4. To change Collection Bag (#36), wear ANSI approved impact safety goggles,
and a dust mask. Remove the Belt (#34) and empty the bag. Replace the
Belt (#34) .
Step 10) Place the Collection Bag (#36) on the bottom of the Collector (#33) and
secure it with a clamp as in step 9.
Step 11) Attach the Handle (#37) to the Collector (#33) with Nut and Bolt (#39)-see
Figure 6.
Handle (#37)
Nut and Bolt (#39)
Figure 6