Filter
Top Products
Page 4 For technical questions, please call 1-800-444-3353. SKU 67696
68149
Do not leave the compressor 5.
unattended for an extended period
while plugged in. Unplug the
compressor after working.
Keep compressor well-ventilated. Do 6.
not cover compressor during use.
Drain Tank daily and after use. Internal 7.
rust causes tank failure and explosion.
Do not remove the valve cover or adjust 8.
internal components.
Compressor head gets hot during 9.
operation. Do not touch it or allow
children nearby during or immediately
following operation.
Do not use the air hose to move the 10.
compressor.
Release the pressure in the storage tank 11.
before moving.
The use of accessories or attachments 12.
not recommended by the manufacturer
may result in a risk of injury to persons.
All air line components, including hoses, 13.
pipe, connectors, lters, etc., must be
rated for a minimum working pressure
of 150 PSI, or 150% of the maximum
system pressure, whichever is greater.
USE OF AN EXTENSION CORD IS NOT 14.
RECOMMENDED. If you choose to use
an extension cord, use the following
guidelines:
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’ 50’ 100’ 150’
0 – 6 18 16 16 14
6.1 – 10 18 16 Do not use.
10.1 – 12 16 16 Do not use.
12.1 – 16 14 12 Do not use.
TABLE A
Make sure your extension cord is in a.
good condition.
Use an extension cord which is heavy b.
enough to carry the current your product
will draw. An undersized cord will cause
a drop in line voltage resulting in loss of
power and overheating. Table A shows
the correct size to use depending on
cord length and nameplate ampere
rating. If in doubt, use the next heavier
gauge. The smaller the gauge number,
the heavier the cord.
Industrial applications must follow OSHA 15.
guidelines.
Maintain labels and nameplates on the 16.
compressor. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools for
a replacement.
This product is not a toy. Keep it out of 17.
reach of children.
People with pacemakers should 18.
consult their physician(s) before use.
Electromagnetic elds in close proximity
to heart pacemaker could cause
pacemaker interference or pacemaker
failure.
WARNING: The brass components of 19.
this product contain lead, a chemical
known to the State of California to cause