Filter
Top Products
SKU 92658 For technical questions, please call 1-800-444-3353. Page 7
22. This Tile Saw must be plugged into a GFCI (Ground Fault Circuit Interrupter)
outlet. Failure to do so can cause shock resulting in serious injury or death.
Have a qualified electrician install a GFCI outlet for you.
23. Never run the Tile Saw without a water supply. Running the unit without a
water supply will cause irreparable damage to the Pump.
24. Make sure the water supply used for the Tile Saw is not dirty, sandy, and
does not contain any corrosive chemical products.
25. Make sure to change the water when necessary while in use and rinse out
the Tub after every use.
26. Always keep the water level at the recommended level. Fill the Tank with
enough water so that the Pump is about 3/4 completely submerged, but not so
much water that the Tank overflows.
27. Avoid splashing water on the Motor, Power Switch, Power Cord, or any
other electrical component. Make sure to stand on a dry, insulated surface
such as a rubber mat while using the Tile Saw.
28. WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of
California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are: lead from lead-based paints, crystalline silica
from bricks and cement or other masonry products, arsenic and chromium from
chemically treated lumber. Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code 25249.5, et seq.)
29. WARNING! People with pacemakers should consult their physician(s)
before using this product. Electromagnetic fields in close proximity to a heart
pacemaker could cause interference to or failure of the pacemaker.
30. Before using the Tile Saw, make sure the Saw Blade is properly mounted.
Make sure the Saw Blade is balanced, and is not cracked or bent.
31. The Saw Blade will become hot while cutting. Allow the Saw Blade to
completely cool before handling.