Filter
Top Products
SKU 92658 For technical questions, please call 1-800-444-3353. Page 8
32. Allow the Saw Blade to spin up to full speed before feeding a workpiece
into it. When turning off the Tile Saw, allow the Saw Blade to spin down and
stop on its own. Do not press against the Saw Blade to stop it.
33. Do not force the workpiece into the Saw Blade when cutting. Apply moder-
ate pressure, allowing the Saw Blade to cut without being forced.
34. Turn off the Tile Saw and allow the Saw Blade to stop on its own if the Saw
Blade is to be backed out of an uncompleted cut.
35. Never attempt to remove material stuck in the moving parts of the Tile Saw
while it is plugged in and running.
36. When cutting a large workpiece make sure its entire length is properly
supported. If necessary, use a roller stand (not included) with larger
workpieces.
37. Never stand on the Tile Saw. Serious injury could result if the Tile Saw is
tipped or if the rotating Saw Blade is accidently contacted.
38. Industrial applications must follow OSHA requirements.
39. For your safety: In extreme working conditions, sensors in the Tile Saw will
automatically switch off the Motor to prevent overheating. In this event, turn the
Power Switch to its “OFF” position. Wait five minutes or until the Motor has
cooled. Making sure your hands are dry, depress the Circuit Breaker. Then, turn
the Power Switch to its “ON” position to resume cutting. NEVER attempt to
disable the Circuit Breaker.
40. Never attempt to cut more than one tile at a time.
41. Never attempt to cut freehand. Make sure the tile to be cut is pressed firmly
against the Rip Fence.
42. Never cut pieces too small to be held securely against the Rip Fence with
out leaving enough space for the hand to be a safe distance from the Saw
Blade.
43. Make sure the tile to be cut has sufficient room to move sideways.
Failure to do so may result in the tile binding against the Saw Blade.
44. Make sure the Table and surrounding area are clear with the exception of
the tile to be cut.