Filter
Top Products
SKU 93364 For technical questions, please call 1-800-444-3353 PAGE 10
4. CAUTION! All maintenance, service, and repairs not discussed in this
manual should only be performed by a qualified service technician.
TROUBLESHOOTING
3. To clean, use a clean cloth and mild detergent or non-flammable solvent. Then,
dry.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
Problem Possible Solution
Tool not cutting properly or not
forming a proper bead.
Check to make sure workpiece is no thicker than 18 gauge.
Check Cutting Dies/Flange Dies for proper alignment.
Make sure all Hex Bolts are tightened.
Check Collars for proper setting and adjustment.
Check for worn Cutting Plates/Flange Dies. If necessary, replace
Cutting Plates/Flange Dies.
Lubricate all moving parts.
Handle turns with difficulty. Check to make sure workpiece is no thicker than 18 gauge.
Check for proper adjustment of Thickness Adjusting Bolt.
Check for damaged parts (Gears, Rollers, Dies, Flanges, etc.)
Lubricate all moving parts.