Filter
Top Products
OPERATING INSTRUCTIONS
1. CAUTION! Do not exceed the maximum thickness capacity (18 gauge) of
the Bead Roller.
2. Always use two people to operate the Bead Roller. One person should guide the
metal along the Roller while a second person cranks the Handle (12) of the tool.
Metal forming typically requires good communication between the person
cranking the Handle and the person guiding the metal, particularly on corners.
NOTE: It is recommended to practice all cutting/beading procedures first on
scrap metal. (See Figure F.)
3. Mark your rib, flange pattern, or cut-line on the workpiece. (See Figure F.)
4. Insert and guide the workpiece through the Cutting Dies or Flange Dies while
another person cranks the Handle (12) of the tool. (See Figure F.)
5. When finished using the Bead Roller Kit, make sure to store the tool and its
accessories in a clean, dry, safe location out of reach of children.
PERSON #1
CRANKS
HANDLE
(15)
PERSON #2)
FEEDS
WORKPIECE
FIGURE F
INSPECTION, MAINTENANCE, AND CLEANING
1. Before each use, inspect the general condition of the Bead Roller Kit. Check for
misalignment or binding of moving parts, damaged or loose parts, dull or worn
Cutting Dies and Flange Dies, and any other condition that may affect the tool’s
safe operation. If abnormal noise or vibration occurs, have the problem cor
rected before further use. Do not use damaged equipment.
2. Periodically, use grease to lubricate all moving parts of the Bead Roller.
SKU 93364 For technical questions, please call 1-800-444-3353 PAGE 9