Filter
Top Products
SKU 93364 For technical questions, please call 1-800-444-3353 PAGE 5
INSTALLATION AND ASSEMBLY INSTRUCTIONS
1. CAUTION! The Bead Roller is heavy. Always use
two
people when lifting or
moving the tool.
2. Use a standard shop vise (not included) to securely hold the Bead Roller. Make
sure the vise is bolted or permanently fastened to a flat, level, sturdy workbench
capable of supporting the weight of the Bead Roller, vise, workpieces, and any
additional tools. (See Figure A.)
3. Once the Bead Roller is secured in a vise, align the flat inner edge of the Handle
(12) with the flat edge of the Active Roller (3). Then, slide the Handle onto the
Active Roller. (See Figure A.)
4. Use a 3/8” open end wrench to firmly tighten the Bolt (11). (See Figure A.)
BOLT (11)
ACTIVE ROLLER (3)
HANDLE (12)
VISE
(NOT INCLUDED)
FIGURE A
ALIGNMENT
NOTE: The Bead Roller has been factory pre-aligned. However, depending on
use the Bead Roller may eventually require re-alignment. Poor alignment will
affect the quality of metal forming and the ability of the tool to cut sheet metal. If
you experience either of these problems, perform the following alignment steps:
1. Set up the Bead Roller with Cutting Dies (10-1, 10-2) and Cutting Plates (9) as
shown in the illustration. (See Figure B, next page.)
2. Inspect the Cutting Plates (9). When the Bead Roller is properly aligned, the