Filter
Top Products
SKU 93496
For technical questions please call 1-800-444-3353
Page 3
6. Dress properly while working. Do not wear loose clothing or jewelry as they
can be caught in moving parts. Protective, electrically non-conductive work
clothes and non-skid footwear are recommended when working. Wear
restrictive hair covering to contain long hair. Always wear work boots and
work gloves.
7. Use eye and ear protection. Always wear ANSI approved impact
safety goggles. Wear a full face shield if you are producing metal
filings or wood chips. Wear an ANSI approved dust mask or
respirator when working around metal, wood, and chemical dusts and
mists.
8. Do not overreach. Keep proper footing and balance at all times.
Do not reach over or across running machines.
9. Maintain tools with care. Keep tools clean and in good condition for better
and safer performance. Follow instructions for lubricating and changing
accessories. Inspect tool fittings and hoses periodically and, if damaged,
have them repaired by an authorized technician. The handles must be kept
clean, dry, and free from oil and grease at all times.
10. Disconnect Air Hose and release any built-up air pressure. Never service
the Nailer, clear jams, or disassemble with the air hose attached. Always
release any built-up air even after disconnecting hose. Disconnect the Nailer
when not in use.
11. Remove adjusting keys and wrenches. Check that keys and adjusting
wrenches are removed from the tool or machine work surface before
connecting it.
12. Avoid unintentional starting. Be sure the switch is in the Off position when
not in use and before attaching to pressure source. Do not carry any tool with
your finger on the trigger, whether it is attached or not.
13. Stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired.
14. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment and binding of moving
parts; any broken parts or mounting fixtures; and any other condition that may
affect proper operation. Any part that is damaged should be properly repaired
or replaced by a qualified technician. Do not use the tool if any switch does
not turn On and Off properly.
15. Guard against electric shock when working on electrical equipment.
Prevent body contact with grounded surfaces such as pipes, radiators,
ranges, and refrigerator enclosures.