Filter
Top Products
SKU 93496
For technical questions please call 1-800-444-3353
Page 5
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Air Pressure Supply
This tool is designed to operate with a maximum air pressure of 125 psi. You must
use an air regulator, set at 125 psi or below. Note: Performance of this tool may
vary depending on variations in local air pressure.
In use, this tool will use 2 - 4 Cubic Feet per Minute of compressed air at 125 psi.
For satisfactory performance, you must use an air compressor capable of deliver-
ing this volume of air at the stated pressure.
We recommend that you use both a filter and an in-line oiler in your air supply
system as illustrated in the diagram below. These components are not included
with this tool, but are available from Harbor Freight Tools.
If you do not use a filter and in-line oiler, put a few drops of water displacement oil
into the air line before each use. After each use, the Air Hand Nailer should be
carefully drained of collected moisture and sprayed with a water displacement oil.
We recommend that you install a quick-release nipple (not included) into the Air
Inlet (23). Quick release connectors at all points in an air pressure system make
your work easier.
Air Palm
Nailer
Unpacking
When unpacking, check to make sure the following parts are included.
Air Palm Nailer Tool
Leather Cover
(1) 4mm Hex Key
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
REV 11/06