Filter
Top Products
SKU 93496
For technical questions please call 1-800-444-3353
Page 7
NOTE: Some parts are listed and shown for illustration purposes only and are not
available individually as replacement parts.
Parts List
Maintenance
1. Place a few drops of light weight air tool oil (not included) into the Air Inlet (23)
each time before using the tool.
2. After each use, drain any accumulated moisture from the tool, and spray a
small amount of water displacing oil into and on the tool. Wipe clean.
3. Store tool in a safe location out of reach of children and unauthorized persons.
Troubleshooting
Tool will not operate.
1. Possible cause: Low or no air pressure.
Solution: Check air compressor to be sure it is operating properly. Check Air
Regulator. Check air lines for leaking or blockage.
2. Possible cause: Corroded Piston (8).
Solution: Spray light weight penetrating oil into the Air Inlet (23). If tool still
won’t operate, take it to a qualified service technician for repair.
3. Possible Cause: Damaged Seals or O rings.
Solution: Take it to a qualified service technician for repair.
#traPnoitpircseD.YTQ#traPnoitpircseD.YTQ
1ydoB141gniRrebbuR1
2xoBediuG151gniRO1
3piTremmaH161evlaV1
4rehsaWgnirpS171gniRO1
5gnirpS181re
voCraeR1
6repmaDrebbuR191gnikcaPevlaV1
7gniRO102gniRO1
8notsiP112teksaG1
9doRnotsiP122wercS4
01gniRO132telnIriA1
11gniRO142hcnerWxeH1
21redn
ilyC152)nwohston(revoCrehtaeL1
31revoCrednilyC1
Note: A hex wrench is included for removing hex bolts when removing the Rear
Cover (18).This work should only be done by a qualified service technician.
Hex Bolt