Filter
Top Products
SKU 94443
For technical questions, please call 1-800-444-3353
Page 7
Unpacking
When unpacking, check to make sure the following parts are included.
8” wet tile saw with electric motor and tub
Sliding table with adjustable miter guide.
45° bevel block. Arbor wrench and screwdriver
Diamond blade. Blade guard. Owner’s Manual.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Assembly
Before using your 8” Wet Tile Saw for the first
time, you must install the Blade and Blade Guard,
and fill the Water Tank with water.
1) Be sure that the machine is unplugged and that
the Power Switch (14) is turned to the OFF
position.
2) Open the Access Cover (41) to expose the Arbor
Shaft (11). Remove the Locking Arbor Nut (38)
and Outer Flange (39).
3) With the Inner Flange (36) in place, slide the Blade
(37) onto the Arbor Shaft (11) with the rotation
arrow on the Blade pointing in the same direction
as the rotation of the motor. Place the Outer
Flange (39) on the shaft against the outer surface
of the Blade. Screw the Locking Arbor Nut (38)
onto the Arbor Shaft. Use the provided accessory
Screwdriver to hold back the Arbor Shaft, while
tightening the Locking Arbor Nut with the provided
accessory Wrench. Turn the Wrench clockwise to
tighten.
4) Position the Blade Guard (46) as shown in the
picture. Fix in place using Screws (44). Be sure
the Blade Guard is in place covering the blade but
does not contact the Blade.
5) With the power cord unplugged and the Power
Switch (14) turned OFF, fill the water container to
just below the opening on the Overfill Plug (53).
Pour the water into the Water Tank (31) through the
opening under the Access Cover (41). Do not
allow water to splash on the Motor (22).
Tightening the Locking Arbor Nut
Installing the Blade Guard (46)