Filter
Top Products
SKU 94443
For technical questions, please call 1-800-444-3353
Page 8
Angle Guide
Tool Rest (31)
Tool Rest Adjusters (34)
Operation
Preliminary Safety Check
Before starting the saw, with the power cord unplugged, and the Power Switch turned to the
OFF (“O”) position, check to ensure:
a) The safety shield is in place and properly adjusted.
b) The cutting wheel can be revolved freely by hand.
c) The Sliding Table is in place.
d) The tub has enough water to keep the blade wet.
e) The Access Cover is in place.
f) The wet saw is positioned on a solid, level surface which is sturdy enough to safely support the
tool and your work materials.
Using the Sliding Table
The Sliding Table is an advanced feature of
this product which aids in making safe and
accurate cuts.
1) Grasp the handle of the Support Bar (50) and pull
it straight out as far as needed to support the size
tile you plan to cut.
2) If necessary, remove the Support Rod (52) from its
storage location under the Access Cover (42), and
place it under the Support Bar (50).
3) Unlock the Sliding Table (1) by moving the Table
Locking Switch (54) to the “Unlock” position as
shown in the photo.
4) The Sliding Table may now be moved forward and
back along the top of the tool.
Basic Cutting Operation
1) Pull the Sliding Table (1) back far enough from the
Blade (37) to place the tile on the table.
2) After making sure that it is safe to turn the power
on, turn the Power Switch (14) to the ON position.
Allow the Blade to come up to full speed. Check
to be sure that the Blade is wet.
3) Using both hands, hold the tile securely against
the fence at the back edge of the Sliding Table.
WARNING: Do not allow your hands or fingers
to protrude over the notch at the back edge of
the Sliding Table. The Blade will enter this
space during the cutting operation.
4) Slowly push the Sliding Table and tile forward
into the Blade (37). Feed the workpiece smoothly
into the Cutting Blade (37). Do not apply heavy pressure or bump the workpiece against the Cutting
Blade. Try to allow the Cutting Blade to continue to turn at full speed as you work.