Filter
Top Products
SKU 94585 For technical questions please call 1-800-444-3353. Page 4
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. USE CLEAN, DRY, REGULATED COMPRESSED AIR AT 90 PSI. Do not exceed the
recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases or any
other bottled gas as a power source for this tool.
3.
ALWAYS DISCONNECT TOOL FROM ITS COMPRESSED AIR SUPPLY SOURCE
BEFORE PERFORMING ANY SERVICES OR MAINTENANCE such as cleaning the
tool, changing chisels or punches, moving to a different work location, handing the tool to
another person, etcetera. Caution: After disconnecting the TOOL from the air
compressor, the TOOL will still be pressurized. Point the TOOL onto an extra piece of
work surface and depress the trigger until all pressure is released.
4. MAINTAIN A SAFE WORK ENVIRONMENT. Keep work area well lit. Make sure there is
adequate surrounding work space. Use this product in a well ventilated area. Do not
operate this product in the presence of flammable liquids, gasses, or dust.
5. DO NOT FORCE THE EQUIPMENT. This product will do the work better and safer at
the speed and capacity for which it was designed.
6. AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin work before
depressing the Trigger.
7. NEVER POINT TOOL AT PEOPLE OR ANIMALS.
8. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities, contain chemicals known (to the State of California) to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals
Air
Drill
Airline Oiler Assembly
2. WHEN CONNECTING TO THE AIR SUPPLY:
A. Wrap approximately 4” of Teflon tape around the male threads of a 1/4” NPT Quick
Connector (not provided). Then, wrench tighten the Quick Connector into the Air Inlet.
B. If an automatic oiler is not used, add two drops of oil into the Quick Connector.
C. Turn on the compressor and set the regulator to the pressure recommended for this
tool (90 PSI).