Filter
Top Products
SKU 41453 For technical questions, please call 1-800-444-3353. PAGE 4
To comply with the National Electric Code (NFPA70), and to provide additional
protection from the risk of electrical shock, the Cut-Off Saw should only be
connected to a
115 Volt, 3 prong, electrical outlet that is protected by a Ground
Fault Circuit Interrupter (GFCI).
3. ALWAYS USE A 3 PRONG PLUG ADAPTER (not provided). This Cut-Off Saw
is equipped with a
2 prong
Power Cord Plug (31). For increase safety always
attach and use a
3 prong
, grounded, Plug Adapter. (See Figure A, and Assy.
Diagram.)
FIGURE A
4. MAKE SURE THE POWER SWITCH IS IN THE “OFF” POSITION BEFORE
PLUGGING IN THE POWER CORD.
5. DO NOT ABUSE THE POWER CORD. Do not use the Power Cord to pull the
Plug from a power outlet. Keep Power Cord away from heat, oil, sharp edges, and
moving parts. Replace a damaged Power Cord immediately. Route the Power
Cord safely. Protect it from being damaged by other equipment in the work area.
Do not route the Power Cord where it can be walked on or tripped over.
6. IF YOU USE AN EXTENSION CORD, MAKE SURE TO USE ONLY UL
APPROVED CORDS HAVING THE CORRECT GAUGE AND LENGTH.
(SEE FIGURE B.)
REQUIRED EXTENSION CORD GAUGE
Nameplate Extension Cord Length
Amperes 25’ 50’ 75’ 100’ 150’ 200’
0 - 5 16 16 16 14 12 12
5.1 - 8 16 16 14 12 10 -
8.1 - 12 14 14 12 10 - -
12.1 - 15 12 12 10 10 - -
15.1 - 20 10 10 10 - - -
FIGURE B
3 PRONG PLUG ADAPTER
2 PRONG PLUG (31)
115 VOLT OUTLET