Filter
Top Products
SKU 41453 For technical questions, please call 1-800-444-3353. PAGE 8
FIGURE D
OPERATING INSTRUCTIONS
For additional references to the parts listed below, refer to pages 10 and 11 of this
manual.
1. WARNING! Do not use unapproved accessories. Do not use circular saw
blades or wire brushes on this tool. Do not use any accessory except 6”
Cut-Off Grinding Wheels rated at 9,000 RPMs or higher.
2.
NOTE: Be aware that friction from cutting will heat up both the wheel and work-
piece. Do not overwork the Cut-Off Saw, as damage may result.
3. Determine the angle of cut required, and adjust the Fixed Vise (57) to the degree
of angle required, using the Scale located on the Fixed Vise. The Fixed Vise can
be set from 0 to 45 degrees. To adjust the angle, loosen the Screw (58). Set the
angle required. Then, retighten the Screw. (See Figure C, and Assy. Diagram.)
4. Insert the workpiece between the Fixed Vise (57) and Moveable Clamp (55).
(See Figure C, and Assy. Diagram.)
5. Turn the Knob (47)
clockwise
to secure the workpiece in place between the Fixed
Vise (57) and Moveable Clamp (55). (See Figure C, and Assy. Diagram.)
6. Hold the Handle with one hand, and pull it down slightly toward the workpiece.
Make sure the Cut-Off Grinding Wheel is aligned with the workpiece and cutting
slot located on the Base (60). (See Figure C, and Assy. Diagram.)
7. Depress the Power Switch (42) to turn on the tool, and allow the Cut-Off Grinding
Wheel to come to full speed. (See Figure C, and Assy. Diagram.)
REV 01/04; 01/05; 12/05
OUTER
FLANGE (1)
SPINDLE
(10)
5/8” ARBOR 6” CUTOFF
GRINDING WHEEL
(NOT PROVIDED)
5/8” ARBOR BLADES 7/8” ARBOR BLADES
INNER FLANGE (3)
OUTER
FLANGE (1)
SPINDLE
(10)
7/8” ARBOR 6” CUTOFF
GRINDING WHEEL
(NOT PROVIDED)