Filter
Top Products
SKU 41453 For technical questions, please call 1-800-444-3353. PAGE 6
20. MAINTAIN CONTROL OF THE WORKPIECE AT ALL TIMES. Whenever
possible, secure the work piece with clamps, in a vise, etcetera.
21. ALWAYS DISCONNECT THE CUTOFF SAW FROM ITS ELECTRICAL
SUPPLY SOURCE BEFORE PERFORMING ANY SERVICES OR
MAINTENANCE. Unplug the Cut-Off Saw when leaving the work area, moving
the tool from one location to another, changing Cut-Off Grinding Wheels,
cleaning debris from the tool, etcetera.
22. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are: lead from lead-based paints, crystalline silica from bricks
and cement or other masonry products, arsenic and varies, depending on how
often you do this type of work. To reduce your exposure to these chemicals; work
in a well ventilated area, and work with approved safety equipment, such as those
dust masks that are specially designed to filter out microscopic particles. (Califor-
nia Health & Safety Code § 25249.5,
et seq.)
23. WARNING: People with pacemakers should consult with their physician(s)
before using this product. Operation of equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
UNPACKING
When unpacking, check to make sure all parts listed and shown on pages 10 and 11
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
For additional references to the parts listed below, refer to pages 10 and 11 of this
manual.
To Install A 6” Cut-Off Grinding Wheel:
1. Caution: Prior to installing a Cut-Off Grinding Wheel (not provided), make sure
the Cut-Off Saw is disconnected from its electrical power source.
2. Release the Chain (51), and allow the Housing (22, 44) to rest in its full upward
position. (See Figure C, and Assy. Diagram.)