Filter
Top Products
Page 2SKU 93981 For technical questions, please call 1-800-444-3353
SPECIFICATIONS
Power Requirement 120 VAC, 60 Hz
Motor 3/4 HP Input, 1/3 HP Output
Disc Speed 1780 RPM
Belt Speed 1150 FPM
Switch Toggle with Safety Lock
Sanding Belt Size 4 (W) x 36 (L) inches, 80 grit
Sand Disc Size 6 inch diameter, 80 grit
Table Size 7-1/2 (W) x 5 (L) x ¾ (D) inches
Table Tilt 0 ~ 60 degrees downward
Miter Gauge 5 x 3-1/4 x 1-5/8 (H) inches; 0 ~ 60 degree L/R
Overall Dimensions 24-3/4 (H) x 15 (W) x 14 (D) inches
Weight 37.5 lb.
SAVE THIS MANUAL
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in
electric shock, fire, and/or serious injury.
SAVE THESE INSTRUCTIONS
Work Area
Keep your work area clean and well lit. Cluttered benches and dark areas invite
accidents.
Do not operate power tools in explosive atmospheres, such as in the presence
of flammable liquids, gases, or dust. Power tools create sparks which may ignite
the dust or fumes.
Keep bystanders, children, and visitors away while operating a power tool. Dis-
tractions can cause you to lose control. Protect others in the work area from debris
such as chips and sparks. Provide barriers or shields as needed.
Electrical Safety
Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and
refrigerators. There is an increased risk of electric shock if your body is grounded.
Do not expose power tools to rain or wet conditions. Water entering a power tool
will increase the risk of electric shock.
1.
2.
3.
1.
2.
REV 09/06