Filter
Top Products
Page 10SKU 93981 For technical questions, please call 1-800-444-3353
OPERATING INSTRUCTIONS
Horizontal to Vertical
Pivot Hex Nuts (13)
Belt Tracking Ad-
justing Knob (35)
Belt Tension
Lever (34)
Switch (16)
Switch Key
Table Angle
Adjusting Knob (55)
Table Angle Scale
Table (59)
Angle Pointer (58)
Controls and Adjustments
Mount the Table Tilt Trunion (56) to the Table (59) using Hex Bolt (51), Flat Washer (53),
and Lock Washer (52). Securely tighten. See photos at the bottom of page 9.
Mount the other end of the Table Tilt Trunion (56) to the Pivot Bracket (48) using Flat
Washer (54) and Adjusting Knob (55). Securely tighten.
Slide the Pivot Bracket (48) all the way onto the Rod (47) and tighten Set Screw (50).
Mounting the Block Stop
Remove Disc (22) by loosing Set Screw (17) and pulling the Disc off.
Block Stop (7)
Hex Bolt (20)
Flat Washer (21)
Platen (8)
For sanding using the Belt (4), mount the Block Stop (7) to the Platen (8) using Hex
Bolt (20) with Flat Washer (21). Securely tighten.
3.
4.
5.
1.
2.