Filter
Top Products
2
-
1. Installation and maintenance to be performed only by certied personnel who are familiar with this type of
equipment.
2. Make sure that all eld wiring conforms to the requirements of the equipment and all applicable national and
local codes.
3. Avoid contact with sharp edges and coil surfaces. They are a potential injury hazard.
4. Make sure all power sources are disconnected before any service work is done on units.
Inspection
Responsibility should be assigned to a dependable individual at the job site to receive material. Each shipment
should be carefully checked against the bill of lading. The shipping receipt should not be signed until all items listed
on the bill of lading have been accounted for. Check carefully for concealed damage. Any shortage or damages
should be reported to the delivering carrier. Damaged material becomes the delivering carrier’s responsibility and
should not be returned to the manufacturer unless prior approval is given to do so. When uncrating, care should be
taken to prevent damage. Heavy equipment should be left on its shipping base until it has been moved to the nal
location.
General Safety Information
Nomenclature
TPC1 - One Condenser Fan Cabinet
TPC2 - Two Condenser Fan Cabinet
TPC3 - Three Condenser Fan Cabinet
© 2011, Heatcraft Refrigeration Products LLC