Filter
Top Products
Carriage Light with
Motion-activated Sensor
Tail Assembly
Coach Light
FEATURES
• Automatically comes on when motion is de-
tected.
• Automatically turns light off.
• Photocell keeps the light off during daylight
hours.
is package includes:
• Mounting screws and wire connectors
REQUIREMENTS
• e Light Control requires 120 volts AC.
• If you want to use Manual Mode, the control
must be wired through a switch.
• Some electrical codes require installation by
a qualified electrician. Please check the codes
in your area.
Model 52-4477-8
Before installation, record the model num-
ber listed inside the xture. Attach receipt
in case of possible warranty issues.
Model Number:
Wire
Path
Junction Box
Screws
Fixture
Screw
Horizontal Junction Boxes Only:
Remove ground screw and 2 fixture screws from
the mounting plate. Flip plate over. Reinsert
ground screw. Insert the 2 fixture screws in the
holes near the junction box screws holes. Wire
path must be located as shown above.
Ground
Screw
Wire Path
Ground Screw
Mounting
Plate
Fixture
Screw
INSTALLATION
Decorative Nut
Mounting Screw
Bracket
Mounting
Screw
Mounting
Plate
Junction
Box
598-1285-00
Note: We recommend having an assistant help hold
the lantern assembly during the wiring process.
For best performance, mount the fixture about 6
feet (1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove mounting plate.
3. Tighten mounting screws finger tight.
4. Attach mounting plate to junction box.
WARNING: Turn power o at circuit
breaker or fuse.
Installation and
Operating Instructions