Filter
Top Products
5
598-1285-00
30 ft.
(9.1 m)
6 ft.
(1.8 m)
150°
3.
Walk through the coverage area noting where
you are when the lights turn on. In TEST mode,
light will stay on for 5 seconds after sensing
motion and then turn off.
4.
Move the sensor head left or right to change
the coverage area. Note: Grasp the sensor only
as shown and turn the entire sensor. Any other
method may damage the sensor. Do not
force it past the stops.
Maximum Range Maximum
Coverage Angle*
(Top View)
Note: When first turned on wait about 1
1
/
2
minutes
for the circuitry to calibrate.
* resets to Auto Mode at dawn.
Least Sensitive Most Sensitive
e sensor is less sensitive to motion directly
towards it and more sensitive to motion across
coverage area.
Sensor
Motion
OPERATION
Mode: On-Time Works: Day Night
Test
5 Seconds
x x
Auto
1, 5, or 10
Minutes
x
Manual
To Dawn*
x
... back on.
1 Second
OFF then...
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
MANUAL MODE
240°
Sensor
Aiming
Adjustment
Angle
5. Adjust the SENSITIVITY to increase or
decrease the range as needed. Too much sen-
sitivity may cause false triggering due to heat
sources in the coverage area (see
Adjustment of
Coverage Area or Troubleshooting
section).
6. Set the amount of ON-TIME you want the
light to stay on after motion is detected (1, 5,
or 10 minutes).
Motion