Filter
Top Products
2
598-1285-00
One Motion Light
Black to black
White to white
Two Motion Lights
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the “pigtail”
with the GND screw on the mounting plate.
Black
White
Green
or Bare
Black
White
Green or Bare
WIRING
CAUTION: DO NOT connect the RED wire
unless you want to control other lights from
the motion sensor (see Optional Wiring).
Note: All wiring must be run in accordance with
the Canadian Electrical Code through conduit
or another acceptable means. Contact a quali-
fied electrician if there is any question as to the
suitability of the system.
WARNING: Turn power o at circuit
breaker or fuse.
Connect the fixture wires to the wires in the junc
-
tion box. Twist the wires together and secure with
wire connectors.
If you have metal junction box, you may not need
the green “pigtail”. If you are unsure about the
grounding method, consult your local building
code.