Filter
Top Products
4 Software Installation On The Head Node
This chapter contains notes that apply to the HP XC System Software Kickstart installation
session.
4.1 Manual Installation Required For NC510F Driver
The unm_nic driver is provided with the HP XC software distribution, however, it does not load
correctly.
If your system has a NC510F 10 GB Ethernet card, run the following commands to load the driver:
# depmod -a
# modprobe -v unm_nic
Then, edit the /etc/modprobe.conf file and specify unm as the driver for the eth device
assigned to the NC510F driver.
4.1 Manual Installation Required For NC510F Driver 23