Filter
Top Products
— 14 —
English
NAILER OPERATION
Read section titled “SAFETY”(pages 4 – 7).
DANGER
WARNING
ⅷ NEVER point tool at yourself or others in work
area.
ⅷ Keep fingers AWAY from trigger when not driving
nails to avoid accidental firing.
ⅷ Choice of triggering method is important.
Please read and understand “METHODS OF
OPERATION” found below.
ⅷ Never place your face, hands or feet near firing
head when using.
ⅷ Use only genuine HITACHI heat treated nails for
this NR65AK.
ⅷ Be sure to position and insert the first nail point
through the hole in the metal connectors.
ⅷ Do not drive nails at an angle of less than 50
degrees, since the nails can ricochet and hurt
yourself or someone else.
ⅷ Always point first nail protruded from the nose
away from yourself and others.
ⅷ Do not push tool forward when positioning the
first nail in hole.
ⅷ Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit
someone.
ⅷ Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
ⅷ Never use Nailer which is defective or operating
abnormally.
ⅷ Do not use Nailer as hammer.
ⅷ Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
This tool has a Sequential Trip Mechanism (Single Shot)
for use where precision nail placement.
You must first depress the nail point where you want
to drive a nail and then pull the trigger.
After the nail is driven, completely release the trigger
and lift the tool off the work surface.
This tool is not designed for contact trip operation
(bounce fire), and not available for contact trip valve units.
And this tool has a new push lever (safety) mechanism,
this is a different push lever mechanism from another
nailers. The push lever is positioned on top at non firing
and on bottom at firing.
This tool is equipped with a lockout feature that prevents
the tool from being activated when there are 5 or less
nails in the magazine.
METHODS OF OPERATION
There is a method of operation to drive nails with this
Nailer.
It is intermittent operation (Trigger fire) only.
(1) Be sure to position and insert the first nail point
through the hole in the metal connector with finger off
the trigger.
Be sure to position the nail with triangle mark (
) at
noe muzzle.
Keep the tool vertically when driving.
Do not push the tool forward when positioning the
first nail in metal hole.
ⅷ Operators and others in
work area MUST wear
safety glasses with side
shields which conforms
to ANSI Z87.1
specifications.
Metal Hole
mark