Filter
Top Products
— 4 —
English
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
MMMMFOR USING NAILERSMMlMM
READ AND UNDERSTAND ALL INSTRUCTIONS
DANGER
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE SHIELDS.
When operating the Nailer, always wear safety glasses with side shields, and make sure others in
work area wear safety glasses, too.
Safety glasses must conform to the requirements of American National Standards Institute, ANSI
Z87.1 and provide protection against flying particles both from the front and side.
The employer must enforce the use of safety glasses by the Nailer operator and others in work
area.
2. NEVER USE OXYGEN OR OTHER BOTTLED GASES. EXPLOSION MAY OCCUR.
Never use oxygen, combustible gases or any other bottled gases as a power source for the Nailer.
Use of the above gases is dangerous, as the Nailer will explode.
Use only clean, dry, regulated compressed air.
3. NEVER DRIVE NAILS INTO METAL OR CONCRETE.
If the nail is driven into metal or concrete directly, it could ricochet and
hurt yourself as well as others.
4. ALWAYS BE AWARE OF POSITION OF FIRING HEAD.
When the firing head is pointed away from work surface, injuries can
occur.
5. KEEP THE TOOL ALIGNED WITH THE PRE-PUNCHED METAL HOLE WHEN FIRING.
Insert the nail point in direct alignment to the pre-punched metal hole.
Do not align with the surface at an angle of less than 50 degrees.
YES NO
•no-holed metal
•concrete
•pre-punched holed
metal
•wood
YES NO
work surface
NO
Zone
50 deg.
80 deg.
YES Zone
50 deg.
METAL
WOOD
Metal hole
NO
Zone