Filter
Top Products
OM-927 Page 25
5-3. Replacing Drive Roll And Wire Inlet Guide
Ref. 802 601-A
1 Inlet Wire Guide Securing
Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3 Drive Roll
Install correct drive roll for wire size
and type.
4 Drive Roll Securing Screw
Secure drive roll with screw as
shown.
Tools Needed:
2
1
3
4
5-4. Removing Knob From Front Panel
Y Turn Off power.
1 Front Panel
2 Knob
3 Spring Clip
4 Control Shaft
5 Slot
Rotate knob to allow access to slot.
Insert Allen wrench (or stiff piece of
wire) into slot, and while depressing
spring clip, slide knob off control
shaft.
To reinstall, push knob fully onto
control shaft.
Ref. 803 863-B / 802 280-E
1
2
4
3
5
Depress
Spring
Clip
Slide
Knob