Hobart Welding Products OM-474 Welding System User Manual


 
OM-474 Page 24
SECTION 7 MAINTENANCE AND TROUBLESHOOTING
Follow the storage procedure in the engine owners manual if the unit will not be
used for an extended period.
NOTE
7-1. Routine Maintenance
Recycle
engine fluids.
Y Stop engine before maintaining.
. See also Engine Manual and Maintenance
Label. Service engine more often if used in
severe conditions.
* To be done by Factory Authorized Service Agent.
8 h
Wipe up
spills.
Drain water
from fuel system.
See Section 7-4.
Check fluid
levels. See
Section 4-4.
OIL
Full
FUEL
WATER
50 h
Clean air filter. See Section 7-3. Clean and tighten weld
terminals.
100 h
Clean and
tighten battery
connections.
Change oil filter.
See Section 7-6.
Change oil. See
Section 7-6.
200 h
Replace unreadable labels.
250 h
Check and clean
spark arrestor.
See Section 7-8.
500 h
Repair or replace
cracked cables.
Check valve clearance.*
1000 h
Drain sludge
from fuel
tank. See
Section 7-4.
Blow out or
vacuum inside.
During heavy
service, clean
monthly.
Or
FUEL
SLUDGE
Service welding generator
brushes and slip rings. Service
more often in dirty conditions.*
Change fuel
filter. See
Section 7-4.