Filter
Top Products
OM-1581 Page 15
3-8. Air-Cooled Feeder Connections
1 Gas Hose Grommet
2 10 ft (3 m) Gas Hose
3 Rear Of Gas Fitting
Route one end of gas hose through
grommet, and connect hose to rear
of Gas fitting in feeder. Connect
remaining end of hose to
regulator/flowmeter.
4 Weld Cable To Welding Power
Source
Select and prepare weld cable ac-
cording to welding power source
manual.
5 Weld Cable Grommet
6 Current Sensing (Reed) Relay
7 Weld Cable Terminal In
Feeder
Route one end of weld cable
through grommet, through reed
relay, and connect to weld cable
terminal in feeder. Connect
remaining end of cable to positive
(+) weld output terminal on welding
power source.
8 Gun Weld Cable
Be sure that terminal of welding
power source weld cable is in direct
contact with terminal from gun weld
cable. Close and latch door.
Ref. 151 771-A
Tools Needed:
5/8, 1-1/8 in
Top View
4
7
8
Connect To
Positive (+) Weld
Output Terminal On
Welding Power Source
Connect To
Regulator/
Flowmeter
1
5
246 7 3
Rear Panel