Filter
Top Products
Drill a hole for the anchor at a distance of 292
mm ( X ) from the hole center.
Drive the impact anchor and secure.
Screw in the all thread rod (2).
Slip on the base plate (4) over the thread rod.
Fit the washer and tighten nut (1) slightly.
Align the base plate (4) by means of the
adjusting screw (3).
Tighten nut (1).
Fastening by means of a Thread Rod,
Washer and Lock Nut
If, for any reason, the anchoring surface does not provide sufficient hold for the anchor, a
thread rod must be used which passes through the brickwork, the wall or the ceiling and is
secured from the other side by means of a washer and locknut.
Fastening by means of a Vacuum Plate
It is not permitted to fasten the drill stand by means of a vacuum when carrying out overhead
drilling.
Connect the vacuum hose to the vacuum cap (1) and switch on the vacuum pump (2).
Set the vacuum base at the measured position and prime. A vacuum of at least 25 in.Hg must
be reached or until the plate is properly secure. Because this type of fastening depends on the
surface, it can only be implemented on smooth, level and non-porous surfaces. When fasten-
ing the drill stand, it must be ensured that the floor covering is firmly attached to the
undersurface and cannot work its way loose.
1 Nut and Washer
2 All Thread Rod
3 Adjusting Screw
4 Base Plate
X
2
Vacuum Pump
(Actual pump may vary between Regions)
Vacuum Cap, Base Plate and Gasket
1
123