Filter
Top Products
16. Maintenance
For details of maintenance work required for the drill motor, please refer to the enclosed
motor manufacturer’s documentation.
Routine Checks
Check electrical connections routinely before each use.
The following routine checks should be carried out monthly:
Check that all screws and fastening elements are properly secure.
Check the feed handle for easy movement.
Check the drive for easy movement and noise.
Check the column for wear and damage.
Check for movement or play in the drill carriage.
Always disconnect the electrical plug before cleaning your drill stand. The drill is virtually
maintenance-free and only requires cleaning. Never clean the drill motor with water or exces-
sively wet clothes.
Adjusting Carriage
Rollers
Loosen the locknut (1) using a 19mm open
end wrench, turn the eccentric shaft (2)
using an 8mm open end wrench, so there is
only slight pressure of the roller in contact
with the column wear plates (3). Holding
the eccentric shaft in place, tighten the
locknut. Follow this procedure for both
adjusting rollers.
If you are unable to achieve proper adjust-
ment, the rollers and/or column wear plates
may need to be replaced.
1
2
3
125