Filter
Top Products
14 – English
ASSEMBLY
Adjusting the harness
You should always use the harness with the machine to give
maximum control over the machine and reduce the risk of
fatigue in your arms and back.
• Put on the harness.
• Hook the machine onto the harness support hook.
• Adjust the length of the harness so that the support hook
is roughly level with your right hip.
Filling with oil
• Open the cap on top of the bar head
• Fill with Husqvarna saw chain oil.
• Refit the cap.
Check before starting
• Inspect the working area. Remove any objects that could
be thrown out.
• Check the cutting attachment. Never use blunt, cracked or
damaged equipment.
• Check that the machine is in perfect working order. Check
that all nuts and screws are tight.
• Make sure the chain is adequately lubricated. See
instructions under the heading Lubricating the cutting
attachment.
• Check that the cutting attachment always stops when the
engine is idling.
• Only use the machine for the purpose it was intended for.
• Make sure the handle and safety features are in order.
Never use a machine that has any parts missing or has
been modified in relation to the specification.