English
– 3
CONTENTS
Contents Note the following before starting:
Husqvarna AB has a policy of continuous product
development and therefore reserves the right to modify the
design and appearance of products without prior notice.
Long-term exposure to noise can result in permanent hearing
impairment. So always use approved hearing protection.
Please read the operator’s manual carefully and make sure
you understand the instructions before using the machine.
These instructions supplement the instructions that were
included with the machine. For other procedures, please refer
to the operating instructions for the machine.
The machine is only designed for cutting branches and twigs.
KEY TO SYMBOLS
Symbols ....................................................................... 2
CONTENTS
Contents ...................................................................... 3
Note the following before starting: ................................ 3
SAFETY INSTRUCTIONS
Cutting equipment ........................................................ 4
Specification of bar and saw chain .............................. 4
Sharpening your chain and adjusting raker clearance . 5
Tensioning the chain .................................................... 6
Lubricating cutting equipment ...................................... 7
Checking wear on cutting equipment ........................... 8
Safety instructions for using a pruning saw ................. 8
WHAT IS WHAT?
What is what on the saw attachment? (Saw attachment
with shaft PA 1100) ....................................................... 11
What is what on the saw attachment? (Saw attachment
without shaft PA) ........................................................... 12
ASSEMBLY
Fitting the cutting head (Saw attachment with shaft PA
1100)............................................................................. 13
Fitting the cutting head (Saw attachment without shaft
PA) ................................................................................ 13
Fitting the bar and chain .............................................. 13
Fitting the hanging ring ................................................ 13
Adjusting the harness .................................................. 14
Filling with oil ................................................................ 14
Check before starting ................................................... 14
TECHNICAL DATA
Technical data .............................................................. 15
Bar and chain combinations ........................................ 15
EC-declaration of conformity ........................................ 16
!
WARNING! Under no circumstances may the
design of the machine be modified without
the permission of the manufacturer. Always
use genuine accessories. Non-authorized
modifications and/or accessories can result
in serious personal injury or the death of the
operator or others.
!
WARNING! This accessory may only be used
together with the intended clearing saw/
trimmer, see under heading ”Approved
accessories” in chapter Technical data in the
machine’s Operator’s Manual.