2 –
English
KEY TO SYMBOLS
.
Symbols
WARNING! The machine can be a dangerous
tool if used incorrectly or carelessly, which can
cause serious or fatal injury to the operator or
others.
Please read the operator’s manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• A protective helmet where there is a risk of
falling objects
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with applicable
EC directives.
Saw attachment with shaft PA 1100
This machine is not electrically
insulated. If the machine touches
or comes close to high-voltage
power lines it could lead to death
or serious bodily injury. Electricity
can jump from one point to
another by arcing. The higher the
voltage, the greater the distance
electricity can jump. Electricity
can also travel through branches
and other objects, especially if
they are wet. Always keep a
distance of at least 10 m between
the machine and high-voltage power lines and/or any objects
that are touching them. If have to work within this safe
distance you should always contact the relevant power
company to make sure the power is switched off before you
start work.
Saw attachment without shaft PA
This machine is not electrically insulated. If the
machine touches or comes close to high-
voltage power lines it could lead to death or
serious bodily injury. Electricity can jump from
one point to another by arcing. The higher the
voltage, the greater the distance electricity can
jump. Electricity can also travel through
branches and other objects, especially if they
are wet. Always keep a distance of at least 10
m between the machine and high-voltage
power lines and/or any objects that are
touching them. If have to work within this safe
distance you should always contact the relevant
power company to make sure the power is
switched off before you start work.
Always wear approved protective gloves.
Wear sturdy, non-slip boots.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
Switch off the engine by moving the stop
switch to the STOP position before carrying
out any checks or maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.
Filling with chain oil and adjusting oil flow