Husqvarna PA 1100 Saw User Manual


 
8 –
English
SAFETY INSTRUCTIONS
2 Check that the oil channel in the gear housing is clean.
Clean if necessary.
3 Check that the bar tip sprocket turns freely. If the chain
lubrication system is still not working after carrying out the
above checks you should contact your service workshop.
Checking wear on cutting
equipment
Chain
Check the chain daily for:
Visible cracks in rivets and links.
Whether the chain is stiff.
Whether rivets and links are badly worn.
We recommend you compare the existing chain with a new
chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to only 4
mm the chain must be replaced.
Chain drive sprocket
Regularly check the degree of wear on the drive sprocket.
Replace if wear is excessive.
Vibration damping system
Check regularly that the vibration damping element is free
from cracks. Check regularly the degree of wear to the rubber
dampers. Replace them if worn.
Bar
Check regularly:
Whether there are burrs on the edges of the bar. Remove
these with a file if necessary.
Whether the groove in the bar has become badly worn.
Replace the bar if necessary.
Whether the tip of the bar is uneven or badly worn. If a
hollow forms on the underside of the bar tip this is due to
running with a slack chain.
To prolong the life of the bar you should turn it over daily.
Safety instructions for using a
pruning saw
CAUTION! Please read the operator’s manual carefully and
make sure you understand the instructions before using the
machine.
!
WARNING! A faulty cutting attachment may
increase the risk of accidents.
!
WARNING! The machine can cause serious
personal injury. Read the safety instructions
carefully. Learn how to use the machine.
!
WARNING! Cutting tool. Do not touch the
tool without first switching off the engine.