Filter
Top Products
7. Remove transportation strap and keep for later
use should the saw be moved any distance.
Vertical Cutting Plate Assembly
Note: These steps are only necessary if using the
bandsaw in the vertical mode.
1. Disconnect the bandsaw from the power
source.
Raise the arm to the vertical position by turning
the arm stop (A, Fig, 2A) a quarter turn
clockwise, slowing bring the arm to vertical, and
lock in place by turning the hydraulic cylinder
valve to the off position. Caution: Do not pinch
fingers between the arm stop and the arm
bracket.
3. Remove two screws (A, Fig. 3) and remove the
deflector plate (8, Fig. 3).
4. Guide the blade through the slot in the table and
fasten with two screws. See Fig. 4.
5. To lower the arm, turn the hydraulic cylinder arm
to any of the on positions.
2.
Coolant Tank Preparation
Use of a water-soluble coolant will increase cutting
efficiency and prolong blade life. Do not use black
cutting oil as a substitute. Change cutting oil often
and follow manufacturers instructions as to its uses
and precautions.
1. Disconnect the machine from the power
source.
2. Remove the coolant return hose from the tank
cover.
3.
Slide the tank out of the saw base and carefully
remove the lid containing the coolant pump.
Fill the tank to approximately 80% of capacity.
Place the lid back onto the tank and placethe
tank assembly back into the base.
Replace the return hose back into the hole in the
tank lid.
4.
5.
6.
,.;.
"-
",---.
-~
\
I
A
Fig.2A
A
Fig.3
Fig.4
4