Filter
Top Products
Adjusting the Blade Guides
1. Disconnect the machine from the power
source.
2. Loosen knob (A, Fig. 8) and bolt (B, Fig. 8).
Slide te blade guide assemblies as close as
possible to the the materialwithout interfering
with the cut.
3. Tighten knob (A, Fig. 8) and bolt (B, Fig. 8) and
connect machine to the power source.
Vise Adj ustment
.!..) WARNING
To set the vise for 0 to 45 degree cutting:
1.
Remove the bolt and nut assemblies (C, Fig. 9).
2.
Position the vise and re-installas pictured in Fig.
10. Pay particular attention to the bolt hole
location.
3. Set the vise to desired angle, re-install nuts and
bolts, and tighten the nut and bolt assemblies.
4. Adjust the movable vise parallelto the fixed vise
by loosening bolt (A, Fig.10), adjusting to
parallel, and tightening bolt.
To set vise for maximumwidth of stock cutting:
1. Remove the nut and bolt assemblies.
2. Position the vise and re-install the bolt
assemblies as pictured in Fig 9.
Fig.8
"-
Fig.9
Fig.10
7