Filter
Top Products
3. If adjustment is necessary, loosenthe bolts
holding the vice and adjust the vise so that the
square lines up properly. Tighten bolts.
4. Connect machine to the power source.
Adjusting Blade Tracking
Note: Before making any tracking adjustments, try a
new blade. Warped blades will not track.
Blade tracking has been set at the factory and
should not require adjustment. If a tracking
problems occurs, adjust the machine as follows:
1. Move the saw arm to the vertical position and
lock in place by shutting off the hydraulic
cylinder valve.
2. Confirm that blade tension is set properly. To
adjust, see section titled "Adjusting Blade
Tension".
3. Open the back cover by loosening the lock
screws.
5.
Loosen bolts (A, Fig. 15).
B
4. Run the saw and observe the blade. Blade
should run next to but not tightly against wheel
flange.
6. Turn set screw (B, Fig. 15)while observing the
blade tracking on the wheel. Turn the set screw
clockwise to track the blade closer to the wheel
flange. Turn the set screw counter-clockwiseto
track blade away from the wheel flange.
7. Once tracking is set, tighten bolts (A, Fig. 15).
Fig.15
11