Filter
Top Products
8
Assembly
Read and understand all
assembly instructions before attempting
assembly! Failure to comply may cause
serious injury!
Do not attempt to turn on
power before this machine is completely
assembled.
Before Assembly
1. Remove the contents from the shipping
container.
2. Compare the contents of the shipping
container with the list on page 7. Report any
shortages or damage to your JET distributor.
3. Clean all rust protected surfaces with
kerosene or a light solvent. Do not use
lacquer thinner, paint thinner, or gasoline.
These will damage plastic components and
painted surfaces.
Column Assembly
Referring to Figure 1:
1. Place the base (A) on a level floor.
2. Place the column assembly (B) on the base
(A) and align the holes in the column support
with the holes in the base.
3. Using a 17mm wrench, secure the column (B)
with four M10 x 40 hex cap screws (C) to the
base.
Table Bracket
When shipped, the rack ring and rack are bundled
together with the column in plastic wrap.
Referring to Figures 2 and 3:
1. Remove the wrap and take the rack ring (D)
and rack (B) off the column (C).
2. Install the table bracket (A) together with the
rack (B) on the column (C) as shown in
Figure 2.
3. Slide the rack ring (D) over the column (C),
placing it so it rests against the rack (B) as
shown in Figure 3 and tighten firmly with a
3mm hex wrench (provided).
Figure 1
Figure 2
Figure 3