Filter
Top Products
10
Assembly
For assembly convenience, the item letter
designators used throughout the Assembly section
are the same as those used to identify shipping
content and hardware components on pages 8–9.
Stand Assembly
Referring to Figure 5:
1. Select two legs (N),one short stand top support
(H) and one short support plate (E).
2. Attach one end of the stand top support (H) to the
top of the first leg with two carriage bolts (Y), flat
washers (CC), lock washers (DD) and hex nuts
(EE). Attach the other end of the stand top
support (H) to the second leg in the same
manner. Hand-tighten only at this time.
3. Attach a support plate (E) to each leg (N) in the
same manner with two carriage bolts (Y), flat
washers (CC), lock washers (DD) and hex nuts
(EE). Hand-tighten only at this time.
4. Repeat steps 1–3 using the remaining legs,
short stand top support and support plate.
5. Complete the stand construction by attaching
long stand top supports (G) and long support
plates (D) to the leg assemblies constructed in
steps 1–4. Hand-tighten all hardware only at this
time.
6. Place a rubber foot (LL) on a hex cap screw (X),
then insert the threaded end of the screw through
the opening on the bottom of the leg.
7. Secure with flat washer (CC) and hex nut (EE).
8. Attach rubber feet to remaining legs in the same
manner.
9. Place stand upright. Ensure that the stand is on
a level surface and all four legs are contacting
the surface.
10. Tighten all hex nuts with the 10mm wrench (O)
provided.
Mounting Jointer-Planer to Stand
Referring to Figure 6:
1. Place the Jointer-Planer (F) onto the assembled
stand and secure with 4 each socket head cap
screws (BB), lock washers (KK), and flat washers
(JJ).
2. Tighten all socket head cap screws (BB) with
the 5mm hex wrench (Q) provided.
EE
DD
CC
H
Y
EE
DD
CC
E
Y
N
B
EE
CC
LL
X
D
G
Figure 5
Figure 6