Filter
Top Products
12
8.5 Extension wings
Referring to Figure 7:
Make sure mating surfaces are clean and free of
burrs.
1. Attach right extension wing (J) to saw table
using four screws and washers (HP-4/8).
Hand-tighten only at this time.
2. Repeat for left side.
Figure 7
8.6 Extension wing adjustment
Referring to Figure 8:
Level extension wing (J) to saw table using a
straight edge (L). A metal straight edge is ideal,
although a carefully jointed board may also be
used, as shown.
Figure 8
1. Begin with the extension wings raised
slightly higher than the main table. Tighten
the four screws (13mm wrench) under the
extension wing that secure it to the saw
table. Tighten these just enough to hold the
wing in place but loose enough to change
the wing height by tapping on it.
2. Lay straight edge across saw table and
extension wing, extending out past edge of
wing, as shown.
3. Move straight edge to several places along
the wing, as you continue to nudge the
extension wing level with saw table. When
extension wing is level with table, securely
tighten each of the four screws.
4. Repeat steps 1 through 3 for opposite
extension wing.
5. Reinstall right side motor cover.
8.7 Rails and fence
To install front and rear rails and fence, consult
manual M-708482 which accompanies your
fence assembly, then proceed to section 8.9.
8.8 Wood extension table
To install the optional wood table, consult
manual M-708482, which accompanies your
fence assembly, then proceed to section 8.9.
8.9 Switch bracket
Referring to Figure 9:
Use two screws and washers (HP-5/8) to secure
switch bracket (M) to front rail.
Figure 9
8.10 Dust Hood
Referring to Figure 10:
Install dust hood at rear of cabinet, using four
small lock knobs (HP-3). The dust port should
be toward the bottom.
A dust collection system, with minimum capacity
of 350 cubic feet per minute, should be
connected to the port via a 4-inch diameter hose
(not included). Note: Dryer vent hose is not
acceptable for this purpose.
An extensive line of JET dust collectors is
available – contact your dealer or visit our
website for information.