Filter
Top Products
13
Figure 10
8.11 Riving knife
Referring to Figure 11:
Figure 11
1. Set saw blade to 90-degree (vertical)
position and raise it all the way (refer to
section 10.1 – Blade raising/tilt mechanism).
2. Remove table insert by rotating lever (shown
at E, Figure 18) and lifting up insert using
finger hole.
Use care when working
around an installed blade.
3. Through the saw table opening, loosen hand
knob (A, Figure 11) by rotating counter-
clockwise. The floating clamp block (B) will
move away from the fixed block (C), leaving
a gap.
4. Slide tabs of riving knife (D) into slot
between the two blocks, all the way down
onto mounting stud.
5. Tighten the hand knob (A) to secure the
riving knife.
The clamping blocks (B/C, Figure 11) are
adjusted at the factory and no further adjustment
of blade guard and riving knife assembly should
be necessary. However, proper alignment is
very important. Before operating table saw, read
section 8.15 – Aligning Blade Guard and Riving
Knife, to verify and follow the adjustment
procedure if necessary.
8.12 Anti-kickback pawls
Referring to Figures 12.
1. Push and hold the button (A) on the
opposite side of the head to release the
catch pin. Mount the pawl assembly straight
down, in the location shown in Figure 12.
2. Pivot the head and push it downward
(Figure 13) until there is an audible click.
Make sure you hear the click to verify that
pawl assembly is secure!
Figure 12
Figure 13